- Joined
- Nov 16, 2015
- Messages
- 797
- Reaction score
- 154
I used to connect my DOS with my Apexel, then I took the DOS offline for 1 year. I am now trying to connect it to my Apexel via aquabus and power supply, connecting the aquabus with the EB832.
I cannot get the DOS interface to show up in Fusion. The DOS is powered and works fine. I push the manual buttons and the pump turn on. When I go into the modules, it shows it as connected. When I click on system, it is shown. However, if I try to access the gear icon/settings from any of the pathways, it takes me to a blank neptune page.
I looked for a new tile. Nothing new there. The old tiles are there but same thing.... takes me to a blank page.
Any suggestions?
Thanks
I cannot get the DOS interface to show up in Fusion. The DOS is powered and works fine. I push the manual buttons and the pump turn on. When I go into the modules, it shows it as connected. When I click on system, it is shown. However, if I try to access the gear icon/settings from any of the pathways, it takes me to a blank neptune page.
I looked for a new tile. Nothing new there. The old tiles are there but same thing.... takes me to a blank page.
Any suggestions?
Thanks