Cation instantly turned red

  • Thread starter Thread starter Jimdba54
  • Start date Start date
  • Tagged users Tagged users None

Jimdba54

Community Member
View Badges
Joined
Aug 16, 2019
Messages
30
Reaction score
6
Location
Seminole
What state or country do you live in
Florida
Rating - 0%
0   0   0
I just added cation and anion to my RO system because I'm going thru mixed bed resin very quickly. The cation resin is purple, as soon as the water from my RO cartridge started filling the canister the resin started turning red/orange. Is this normal, it doesn't look like it. The resin is from BRS. I backwashed the RO cartridge for 5 minutes. My system in order Sediment, two carbon blocks(chloramines), 100 GPD RO cartridge (less than 6 mod old), cation, anion, mixed bed. Water coming out of the RO is 8ppm, slight color change in total/free chlorine strip test.

TIA

...JIM...
 
Not sure. I run deionization resin before those
 
I just added cation and anion to my RO system because I'm going thru mixed bed resin very quickly. The cation resin is purple, as soon as the water from my RO cartridge started filling the canister the resin started turning red/orange. Is this normal, it doesn't look like it. The resin is from BRS. I backwashed the RO cartridge for 5 minutes. My system in order Sediment, two carbon blocks(chloramines), 100 GPD RO cartridge (less than 6 mod old), cation, anion, mixed bed. Water coming out of the RO is 8ppm, slight color change in total/free chlorine strip test.

TIA

...JIM...
Test the TDS into the membrane (after carbon) and then TDS out of membrane. The difference should be close to the rejection rate of the membrane. If it isn't your membrane is bad. It doesn't take much TDS to nuke resins ... regadless.

Also you noted chlorine color change. Nothing will nuke a membrane faster than chlorine of some nature. Chlormines are real and you should be using the special carbon block for those. This is the one at BRS.

https://www.bulkreefsupply.com/matrikx-chloraguard-carbon-block-1-micron.html
 
At 8 ppm TDS, the DI resin should not instantly deplete. Perhaps the red/orange color you are seeing is not the expected amber color of a depleted resin, but just the color it gets with new water running through.
 
Thanks for the responses. I have new carbon blocks on order and BRS sent me replacement resin.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new