Check value

Davebachner

New Member
View Badges
Joined
Oct 10, 2019
Messages
4
Reaction score
0
What state or country do you live in
South Carolina
Rating - 0%
0   0   0
Hi all... I’m in the process of swapping out plumbing up a Replacement tank.


would you recommend using a check value like this, or not use?

Thanks, Dave

965BD0CE-A221-4E8E-B20D-DC667FB13794.png
 
Depends on how you design the return. Avoiding them is generally better because they are prone to failure and put extra back pressure on your pump. BUT, you must have a way to prevent excessive (I.e. sump overflow) back siphon. Best way is to just have the returns close to the tanks surface.
 
The fact that it is clear is good because you can check on the status of the valve but if you do use one know they aren’t foolproof. If used I would make it apart of my weekly maintenance and just check to make sure it is not stuck open
 
If you have an over the back return line, drill an anti-siphon hole just below the water line. It's a bit noisy when the return pump stops, but a surefire way to reduce the water flow from the display tank to the sump.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new