Check valve stammering

Miami Reef

Reef Chem Enthusiast
View Badges
Joined
Sep 8, 2017
Messages
17,251
Reaction score
29,670
Location
Miami
What state or country do you live in
Florida
Rating - 0%
0   0   0
When I close my return pump the check valve stammers. What does this mean?

https://youtube.com/shorts/jkCU5UB1c4U?feature=share

No, this never used to happen. I have 2 return pumps, before only one did it, but stopped after 15 seconds. Now both started doing it, but the 2nd return pump stopped, while the initial one is still doing it.
 
My return pumps are connected to my Apex.
 
I had the same valve, but mounted horizontally on my last setup. Same issue, started doing this after a few months or so. Possibly could need cleaning? Debating not using one my next setup...
 
Plumbing engineering answer:

The most common reason a check valve chatters is turbulence. Very often the turbulence is caused because the check valve is installed too close to the discharge of a pump or is just downstream of an elbow or some other turbulence causing device.

Most people running a check on a reef have it mounted to the pump, or right after an elbow turning horizontal. This causes a water hammer effect, where the water essentially bounces until it comes to rest.

A better location for the valve would be near the outlet but thats usually not easy to do on reefs.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new