Clownfish not doing well

  • Thread starter Thread starter shmoosh
  • Start date Start date
  • Tagged users Tagged users None
Today it seems much better. It's much more active, swims to greet me when I approach the tank, still favors his overflow but he's swimming instead of just floating there.
 
Today it seems much better. It's much more active, swims to greet me when I approach the tank, still favors his overflow but he's swimming instead of just floating there.

Is it feeding well? If so, I'd just observe it for now, based on the apparent improvement.
 
Today it seems much better. It's much more active, swims to greet me when I approach the tank, still favors his overflow but he's swimming instead of just floating there.

Is it feeding well? If so, I'd just observe it for now, based on the apparent improvement.
Yes, it even picked up some food off of the sand bed which I haven't seen it do before.
 
What's your water temperature like? My clown acted weird like in your videos and stayed in the corner except to eat a little. Was like that for a few days. Turned out my heater went kaput and the water temp was like 66. When I noticed and replaced the heater, he went back to normal behavior. I also added an inkbird heater controller with notification alarm. Good luck with your little fella.
 
Last edited:
How long has the tank been running?
 
What's your water temperature like? My clown acted weird like in your videos and stayed in the corner except to eat a little. Was like that for a few days. Turned out my heater went kaput and the water temp was like 66. When I noticed and replaced the heater, he went back to normal behavior. I also added an inkbird heater controller with notification alarm. Good luck with your little fella.
I keep the temp set at 77F, it usually fluctuates from 76-78 throughout the day.
 
How long has the tank been running?
I set the tank up and cycled it around September of last year. I didn't put any fish in until March 17th. Before fish I occasionally dosed with ammonium chloride just to keep any nitrifying bacteria alive (I don't know if that's recommended or not).
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 8 36.4%
  • Powerheads or wavemakers

    Votes: 2 9.1%
  • Sump or rear filtration chambers

    Votes: 2 9.1%
  • Skimmer or other filtration equipment

    Votes: 1 4.5%
  • Overflow or plumbing

    Votes: 6 27.3%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 9.1%
  • Other—tell us what I missed

    Votes: 1 4.5%
Back
Top
Home
Post thread…
Market
What's new