Coral Box Dosing Pump

  • Thread starter Thread starter dabears
  • Start date Start date
  • Tagged users Tagged users None

dabears

New Member
View Badges
Joined
May 5, 2012
Messages
13
Reaction score
4
Location
usa
Rating - 0%
0   0   0
Hi,
I`m at a lost, not sure what to do.
I have a coral box wi-fi doser, I recently had to replace the mother board, because of wi-fi failure. Everything seems to be working fine, all the heads calibrate perfectly. My problem is with the no. 2 head. I also swapped heads but to no avail. The problem is no. 2 is creating a back siphon to the point where the container gets totally full, the containers are below the tank surface line (no sump), and below the doser, I have replace all the check valves with upgraded ones, so i`m at a lost. your suggestions will be highly appreciated, thx.
 
Hi,
I`m at a lost, not sure what to do.
I have a coral box wi-fi doser, I recently had to replace the mother board, because of wi-fi failure. Everything seems to be working fine, all the heads calibrate perfectly. My problem is with the no. 2 head. I also swapped heads but to no avail. The problem is no. 2 is creating a back siphon to the point where the container gets totally full, the containers are below the tank surface line (no sump), and below the doser, I have replace all the check valves with upgraded ones, so i`m at a lost. your suggestions will be highly appreciated, thx.

So the container and doser is below the point where you dose? If that’s the case there’s your problem.
Check valves should help but you will always risk a back siphon.

Is your dosing lines submerged? If so pull them up over the surface. That way you’re at least not risking flooding your floor.
 
So the container and doser is below the point where you dose? If that’s the case there’s your problem.
Check valves should help but you will always risk a back siphon.

Is your dosing lines submerged? If so pull them up over the surface. That way you’re at least not risking flooding your floor.
Yeah, the lines are about a 1/4 in below the surface, I did that so I wouldn`t get any air in the lines. So can ask what I should do .
thx
 
Yeah, the lines are about a 1/4 in below the surface, I did that so I wouldn`t get any air in the lines. So can ask what I should do .
thx

Well, have the lines above the surface. Air in the lines is better than water on the floor.
If you can’t bring the dosing reservoir up I guess the only thing you can do is to get the best check valves possible.
 
Thx, Ill try that and see if it works with air in the line
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new