Corner chipped, frag tank

  • Thread starter Thread starter skr791346
  • Start date Start date
  • Tagged users Tagged users None

skr791346

Active Member
View Badges
Joined
Jan 25, 2018
Messages
240
Reaction score
86
Rating - 0%
0   0   0
Seems to be holding water so far, it's a deep blue 60 gallon rimless frag tank. :(

Concerned because it is the corner of 48" back panel + side panel, glass is only 10mm thick and it's rimless

Somewhat relieved because it's the overflow corner with the plastic overflow acting as additional support for the two panels + where the chip is, water level doesn't reach that high inside the overflow box

What are your thoughts? Is it going to spread? Should I start prepping for a new tank?

dbf.jpg dbf2.jpg dbf3.jpg dbf4.jpg dbf5.jpg dbf6.jpg
 
It's a gamble. Looks to be a hard impact and the glass was fractured behind the silicone. Me, I'd be thinking of replacing it soon.
 
U can try to add silicone sealer as a leak deterrent . I would thx
 
Have to be careful, keep a close eye on it, a replacement will most probably needed.
 
If I silicone a piece of glass on each corner, would that stop any further damage?
 
It's a gamble. Looks to be a hard impact and the glass was fractured behind the silicone. Me, I'd be thinking of replacing it soon.

And yet... I wouldn't be too concerned with that chip...

Being at the top of the glass, water pressure would be minimal. Couple that with the fact the chip is located in the overflow, I am thinking the structure in the corner adds stability.

I'd monitor it and be prepared it if test worse.
 
Thanks everyone. I have a back up tank just in case but for now, I decided to try siliconing a piece of glass each corner for further bracing.
 
Thanks everyone. I have a back up tank just in case but for now, I decided to try siliconing a piece of glass each corner for further bracing.

I think the best piece you could add is a piece that goes across the top forming a triangle, holding the two corners together.
 
I think the best piece you could add is a piece that goes across the top forming a triangle, holding the two corners together.
I was thinking that as well. I wanted to avoid blocking access to the overflow, however. How big of a piece on top do you think will suffice?
 
I was thinking that as well. I wanted to avoid blocking access to the overflow, however. How big of a piece on top do you think will suffice?

Blocking the overflow... I hadn't thought of that... It would have to be something removable... something that would fit across the corner with a groove what would allow it to drop down over the corner, but you could remove to get into the overflow.

I still think it will be Okay.

IMG_7118.jpg
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 19 27.9%
  • I’d trust someone who knows my tank to choose

    Votes: 2 2.9%
  • I’d rather get a gift card and pick it myself

    Votes: 26 38.2%
  • I’d prefer gear or supplies instead

    Votes: 2 2.9%
  • Please don’t surprise me with livestock

    Votes: 19 27.9%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new