cube in wall

baywindow · Jul 4, 2020

Putting an almost cube shaped aquarium in a wall, around 90gallon or 320 liters as we sas in europe, a room divider viewable from two sides. On this picture a stand, which is a good beginning.

andrewey · Jul 4, 2020

Nice! Where in Europe are you located?

baywindow · Jul 4, 2020

I'm in Stockholm, Sweden. And this is a picture of a hole in the wall. Now it only needs a reef.

mefisto · Jul 4, 2020

Nice.
The panels on both sides can be removed I guess? For full servicing and maintenance?

baywindow · Jul 4, 2020

It is in a niche in the wall, I made a plywood prototype. So servicing is from one side, and it will be a bit tight to get to the left and right inner sides. I will leave about an inch so maybe magnets to powerheads can be used.

vetteguy53081 · Jul 4, 2020

baywindow said:
It is in a niche in the wall, I made a plywood prototype. So servicing is from one side, and it will be a bit tight to get to the left and right inner sides. I will leave about an inch so maybe magnets to powerheads can be used.

Very ingenious

Reefkeeper14 · Jul 4, 2020

baywindow said:
It is in a niche in the wall, I made a plywood prototype. So servicing is from one side, and it will be a bit tight to get to the left and right inner sides. I will leave about an inch so maybe magnets to powerheads can be used.

The cabinet opening is really sweet! awesome build so far, good luck