So my loop powerheads quit and while I was untangling the cords to remove them my light shut off. Upon inspection I found the DC power cord must have had a crack in it and poor connection and had burnt one of the pins and some of the plastic around it was gone. The light itself is fine just the cord end needs replacing. Any idea where I can source a replacement plug? The cord itself is part of the light so I'll have to cut the old end of and solder and heat shrink the new one on. I could just cut one of one of the dead powerheads as they use the same plug but the wire for the powerheads is smaller so I'm assuming isn't rated for as much current as the light.