Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I don’t think it’s possible.
Well, I’m actually made it works and the tank is cycling smoothly with the two MP40 running on opposite sides of the tank.Not possible
Wow! Impressive! How did you manage that? Are the magnets just strong enough to hold the wetside in place? Well done.Well, I’m actually made it works and the tank is cycling smoothly with the two MP40 running on opposite sides of the tank.
Yes, the magnets are strong enough to hold the wetsides in place, I only need to cut small pieces of filter flosses in a curve shape follows the curve of the tank and putting them in between the dry and wetsides to prevent scratches and cracksWow! Impressive! How did you manage that? Are the magnets just strong enough to hold the wetside in place? Well done.
Respect !!! Where there's will there will always be a wayWell, I’m actually made it works and the tank is cycling smoothly with the two MP40 running on opposite sides of the tank.
I like the ingenuity, long term you might want to hit up someone on the 3D printing forum to print you something out. The filterfloss will start to catch a lot of stuff over time. You will be good if you swap it out but a simple 3D printed piece to make it sit flush could lessen the maintenance needed, which would be nice for you.Yes, the magnets are strong enough to hold the wetsides in place, I only need to cut small pieces of filter flosses in a curve shape follows the curve of the tank and putting them in between the dry and wetsides to prevent scratches and cracks