DA DPI programming Master pump

Salty1962 · Oct 30, 2015

I'm trying to get my DPI to work as my ato. I've never programmed this before and was looking for some help. It is a Master, no slave, and it will be for ATO.
Thx

elmexotics · Oct 31, 2015

Salty1962 said:
I'm trying to get my DPI to work as my ato. I've never programmed this before and was looking for some help. It is a Master, no slave, and it will be for ATO.
Thx

Which controller do you have? Do you have a float switch setup already? Let me know and I can walk you through this in a snap.

Salty1962 · Oct 31, 2015

elmexotics said:
Which controller do you have? Do you have a float switch setup already? Let me know and I can walk you through this in a snap.

I have the RKL controller. I don't have my float switches setup yet but can get together pretty quick. Do I need to setup the switches on my DPI module or my SL1 module?
I greatly appreciate it!

elmexotics · Nov 3, 2015

Go to the Dp1 -> ch1 -> Function -> Switch -> On Device (select the switch input you have the float connected to) -> On When (select position of the float switch that turns the pump on. You may have to play with this one) -> Off Device (select same float and opposite position of on When) -> Timer 0 -> In Standby Off -> Default off -> Save

Salty1962 · Nov 3, 2015

elmexotics said:
Go to the Dp1 -> ch1 -> Function -> Switch -> On Device (select the switch input you have the float connected to) -> On When (select position of the float switch that turns the pump on. You may have to play with this one) -> Off Device (select same float and opposite position of on When) -> Timer 0 -> In Standby Off -> Default off -> Save

Thx Man, I'll give it a try.