Do powerhead protectors make it so anemones dont get chopped

  • Thread starter Thread starter Rodan
  • Start date Start date
  • Tagged users Tagged users None

Rodan

Active Member
View Badges
Joined
Nov 7, 2022
Messages
141
Reaction score
38
Location
USA
What state or country do you live in
Florida
Rating - 0%
0   0   0
My anemone is near the powerhead, but it has a protector is that ok?
 
That is the idea . What kind of protector is it ie: foam or plastic and are the holes in this protector small enough to where the new can’t get in and get cut up ?
 
That is the idea . What kind of protector is it ie: foam or plastic and are the holes in this protector small enough to where the new can’t get in and get cut up ?
its the Nero plastic protector that comes in the box. One of the tips of the anemone was going inside of it so that was kind of worry sum.
 
its the Nero plastic protector that comes in the box. One of the tips of the anemone was going inside of it so that was kind of worry sum.
Then you might consider getting a foam cover to go over the guard or move the pump
 
its the Nero plastic protector that comes in the box. One of the tips of the anemone was going inside of it so that was kind of worry sum.
The Nero protector isn’t enough IMO.

I bought some cheap plastic canvas (for crafting) from amazon, cut it to size and tied it with a cable tie. I did that for all my powerheads, including Nero 3 and Nero 5.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new