Does anyone have an extra Phosban Reactor?

  • Thread starter Thread starter WesW
  • Start date Start date
  • Tagged users Tagged users None

WesW

Active Member
View Badges
Joined
Apr 12, 2012
Messages
335
Reaction score
0
Location
Athens, AL
Rating - 0%
0   0   0
My algae levels are creeping up and I need to cut them off before they get worse. Does anyone have a phosban reactor they would sell or trade for coral?
 
I have chaeto, fern caulerpa, and mangroves in my sump. I think I'll give the media bag with GFO a shot. Thanks for the suggestion. Do you guys have any other ideas?
 
Test your water and find out where your phosphates and nitrates are at. Then you can proceed.
 
I have chaeto, fern caulerpa, and mangroves in my sump. I think I'll give the media bag with GFO a shot. Thanks for the suggestion. Do you guys have any other ideas?

Loosely pack the bag and put it in a high-flow area of your sump. Certainly a media reactor would work better, but this is a lot cheaper and you should see decent results.
 
Test your water and find out where your phosphates and nitrates are at. Then you can proceed.

Nitrates: 10 ppm
Phosphates: .25 ppm
Alkalinity: 6 dKH

I was just out of town for a week and somehow these current levels are worse than before I left even though the tank was only topped off and given a little flake food while I was gone. I also shortened the light cycle down to seven hours while I was gone.

My alkalinity is low too. What do you guys suggest dosing? Kalkwasser or baking soda?

Thanks for the help!
 
I would do a few water changes back to back to bring the overall nutrient load down firest.
To bring the alkalinity up, I'd use baking soda. Kalkwasser works, too. Try not to raise the alkalinity more than 1 meq/l (2.8 dkh/50 ppm) in a day.
 
I would do a few water changes back to back to bring the overall nutrient load down firest.
To bring the alkalinity up, I'd use baking soda. Kalkwasser works, too. Try not to raise the alkalinity more than 1 meq/l (2.8 dkh/50 ppm) in a day.

Thanks for the advice! I will try doing a 20% water change once a day for the next three days and then see what my levels are. I got phosgaurd and a media bag yesterday. Should I go ahead and put it in my sump now or wait until after I've done the water changes?
 
It does not hurt to set it up. Water changes are good to bring down a high nitrate level quickly. I think GFO is more effective for bringing the PO4 level down.
 
I would do a few water changes back to back to bring the overall nutrient load down firest.
To bring the alkalinity up, I'd use baking soda. Kalkwasser works, too. Try not to raise the alkalinity more than 1 meq/l (2.8 dkh/50 ppm) in a day.

+! agree... you don't want to see the results of increasing the pH or alkalinity too quickly. setup the GFO now, no need to wait for water changes.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new