yet another few questions about setting up my robo tank. @robsworld78
so to set up a dosing pump to robo tank all i need is one of these pumps
these wires
and then solder those wires to the pump, then screw the other side of the wires to a 2 pin terminal.
then i have to connect the main controller to the equipment extension via dc port/ethernet cable and also use the 2-way DC power splitter cable to power both the main controller and the equipment extension. plug it into one of the ports and im good to go.
main questions are
1. are those the correct wires to buy?
2. is there a specific solder i should use?
so to set up a dosing pump to robo tank all i need is one of these pumps
these wires
and then solder those wires to the pump, then screw the other side of the wires to a 2 pin terminal.
then i have to connect the main controller to the equipment extension via dc port/ethernet cable and also use the 2-way DC power splitter cable to power both the main controller and the equipment extension. plug it into one of the ports and im good to go.
main questions are
1. are those the correct wires to buy?
2. is there a specific solder i should use?