Dropped a tiny screw in my tank!!!

blstravler

2500 Club Member
View Badges
Joined
May 5, 2019
Messages
4,204
Reaction score
1,359
Location
Coastal New Jersey
Rating - 100%
4   0   0
So I did a dumb thing.

Was installing a ReefBrite led strip onto my ATI SunPower and the little screw from the SunPower fixture dropped into my tank and it’s gonna be impossible to find....

The screws aren’t magnetic so they could be stainless steel? I can’t think of a way to easily find it - any ideas?

I sent over a question to ATI Support to see if they are stainless or what they are made of.
 
if it is shiny turn off the other lights and shine a bright flash light around the tank and look for reflections. if you think it fell into the sand use a small net like a sand sifter to go through the sand, if you can remove the rockwork pull each piece and invert them over a bucket or tray to see if it drops off. good luck.
 
I've had screws on a skimmer rust out in the tank. Also had a fan placed poorly over a sump which had a screw rust and drip into the tank for years before i noticed. Was never an issue for me. Not sure its an issue if you are doing regular water changes. Aquarium size vs size of screw and frequency of water changes probably have a lot to do with whether or not it will effect the system at all.
 
If it is stainless steel I would assume it’s fine to leave it in?

I’ve been taking out my sand bed for the past few months so I could take the rest out and like suggested above take each piece of rock out and shake it into a bucket of clean water and see if it falls out.
 
I've had screws on a skimmer rust out in the tank. Also had a fan placed poorly over a sump which had a screw rust and drip into the tank for years before i noticed. Was never an issue for me. Not sure its an issue if you are doing regular water changes. Aquarium size vs size of screw and frequency of water changes probably have a lot to do with whether or not it will effect the system at all.

That’s actually a really good point - I probably have about 90 total gallons and I have my AWC set to change a gallon out every day so kinda one third a every month. Also it was a VERY small screw.
 
Your tank is gonna crash
lol thanks for the vote of confidence...

giphy.gif
 
If you need the screw for the light turn I guess you’d better hunt for it. If you’re worried about it affecting the tank .... don’t. Lost count of the number of single edge razor blades I dropped in my tank. BTW, I always put a piece of plywood over my tank when working over it .... mostly because I’m a klutz.
 
I would be super crazy about finding it lol but I doubt it’s going to cause issues
 

TOP 10 Trending Threads

ARE YOU READY TO CONFESS TO CRAZIEST, DUMBEST, FUNNIEST THING YOU’VE EVER DONE IN REEFING?

  • Yeah, I'll confess! (Share your story in the comments!)

    Votes: 66 56.4%
  • Nah, I'll keep mine a secret...(Don't be like that, share with the class!)

    Votes: 51 43.6%
Back
Top
Home
Post thread…
Market
What's new