Dry fit plumbing question

[Mr.Guy83]

Doing a dry run of my plumbing and this is the only location I can think of putting the gate valve on the down drain. However the back of the valve is resting on the back wall of the stand . Will that cause vibration? If so is there a way to remedy it? Thanks
( reefer 170, very limited space)

 

[Greg P]

Shouldn't be an issue. There's nothing going on in a drain to cause the pipes to vibrate.
Just ensure it's not putting pressure on the bulkhead above.

 

[xxkenny90xx]

If it does vibrate at all just wedge some rubber or cloth in there. My return pump has a Mr clean pad wedged next to it

 

[Greg P]

If it does vibrate at all just wedge some rubber or cloth in there. My return pump has a Mr clean pad wedged next to it

It's the OP's drain plumbing - there's nothing to vibrate.

I recommend not wedging anything in there as it'll stress the bulkhead

 

[xxkenny90xx]

It's the OP's drain plumbing - there's nothing to vibrate.

I recommend not wedging anything in there as it'll stress the bulkhead

I wouldn't expect any vibration but I don't know what kind of insane flow could be going through there. Some light cloth (within reason) won't hurt the bulkhead).

 

[Stephensx04]

Wont be an issue as long as its not stressing bulkhead. If anything if you are worried. Put a thin piece of felt between it and stand and secure it with a strap just below valve to stand.