Dual return pumps

  • Thread starter Thread starter Slawman
  • Start date Start date
  • Tagged users Tagged users None

Slawman

Active Member
View Badges
Joined
Feb 2, 2020
Messages
181
Reaction score
205
Location
Sydney, Australia
What state or country do you live in
Australia
Rating - 0%
0   0   0
A few weeks ago my 8000lph primary return failed. All I had on hand at the time were two Tunze silence 3000lph and I put both of them onto it, worked just fine and ended up just as silent (but 2000lph down on flow rate).

I am curious if other reefers use two smaller pumps instead of one large one, I don't see it mentioned much.

Using two pumps has the advantage of being more reliable and you can achieve dead silent running at a lower cost.

Thoughts?
 
Yeah why not? As long as you’re moving the water you want to move, right? Definitely nice to have the back up built in.
 
I've been curious about the plumbing for this setup. Wouldn't you have to have a check valve to prevent flow from working pump exiting the non-working pump? Also, if you run dual, can't one over power the other and cause a reverse flow? I could be overanalyzing pump plumbing.
 
I run two but they are plumbed separately to separate outputs
Me too. No Backflow valves needed. Although I’m moving my sump to the basement so I just purchased an iwaki external pump.
 
I think cost comes into it.
Buying two pumps that deliver the same volume as 1 pump would cost more.
Other than cost it's got positives with redundancy.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new