Cross post @ Neptune Systems Here
Posting here because r2r traffic might help
EB832 has been reporting low voltage the last few mornings - really low temps and lots of heat pumps in the area, but the actual is not as bad as what the eb8 is reporting.
I performed an telnet eb8zero this am with hope that it would also calibrate the voltage for nominal 120.... I know fat chance but I tried it.
EB832 reporting 111v, actual measure with 2 flukes and a harbor freight is 115-116 measured on the same circuit the controller is on. I also turned on a few outlets on the bar and checked the output. It matches line voltage I measured.
Is there a telnet command specifically geared toward correcting this?
Posting here because r2r traffic might help
EB832 has been reporting low voltage the last few mornings - really low temps and lots of heat pumps in the area, but the actual is not as bad as what the eb8 is reporting.
I performed an telnet eb8zero this am with hope that it would also calibrate the voltage for nominal 120.... I know fat chance but I tried it.
EB832 reporting 111v, actual measure with 2 flukes and a harbor freight is 115-116 measured on the same circuit the controller is on. I also turned on a few outlets on the bar and checked the output. It matches line voltage I measured.
Is there a telnet command specifically geared toward correcting this?