EB832 Voltage Calibration - Is it possible

[Staplesofficewar]

Cross post @ Neptune Systems Here

Posting here because r2r traffic might help

EB832 has been reporting low voltage the last few mornings - really low temps and lots of heat pumps in the area, but the actual is not as bad as what the eb8 is reporting.

I performed an telnet eb8zero this am with hope that it would also calibrate the voltage for nominal 120.... I know fat chance but I tried it.

EB832 reporting 111v, actual measure with 2 flukes and a harbor freight is 115-116 measured on the same circuit the controller is on. I also turned on a few outlets on the bar and checked the output. It matches line voltage I measured.

Is there a telnet command specifically geared toward correcting this?

 

[Staplesofficewar]

Bump - must be hard / not possible based on the responses :D

 

[Reefer Reboot]

I don't know about a telnet command but I do remember a conversation a while back about resetting the EB832 V/A/W setting. I can't remember which thread it was in though so I'll just bump this thread for you. Maybe @_AV knows.

 

[Reefer Reboot]

Have you seen this post
https://forum.neptunesystems.com/sh...rting-Amps-or-Watts-at-times-and-undervoltageYou probably have but just in case.

 

[Staplesofficewar]

yup Hit that one. Seems they didnt make it available via telnet for some reason. Not really an issue - just annoying. I might email them when I feel like going back and forth a bit.

 

[_AV]

There is no way to calibrate voltage reading via telnet or anything else that I'm aware of.