Ecotech MP40's Magnetically Disconnect After Feed Mode!

  • Thread starter Thread starter Bato367
  • Start date Start date
  • Tagged users Tagged users None
I shut mine off during water changes. When I turn them back on they start grinding and disconnect. It takes me like 4x making micro adjustments on the position of the magnets before they engage and run smoothly.
 
mine fall off in feed mode. 1/2" glass with no spacers. I have to turn them off and reposition them to get them going again.
 
I have the same problem on mine, anyone found what it is? I’m really starting to hate my vortech
 
Whenever this happens on mine its been the wrong spacer or I didnt align them properly. May sound silly but the glass can distort the image and I end up holding from the inside and the outside to rock them into proper alignment.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new