Excessive Anion DI media usage

  • Thread starter Thread starter QuickrdenU
  • Start date Start date
  • Tagged users Tagged users None
Sorry, but that is not an explanation for unbalanced consumption of the anion resin and not the cation resin. The total positive charges in water will exactly match the negative charges, and they thus deplete both resins.

The only way one can get depletion of only one or the other resin is if the water is very acidic or very basic (not typical of drinking water) or if there are uncharged ions that become charged one way or the other in one of the resins. CO2 fits that latter description, is very common in well water, and is nearly always the cause of selective anion depletion.
Fair point. I have the CO2 problem with my well water as well. Just haven't worked out a good solution yet. Still trying to figure out how to push the correct flow through the DI resin after aeration.
 
Fair point. I have the CO2 problem with my well water as well. Just haven't worked out a good solution yet. Still trying to figure out how to push the correct flow through the DI resin after aeration.

I use a Tunze ATO pump
 
Sorry, but that is not an explanation for unbalanced consumption of the anion resin and not the cation resin. The total positive charges in water will exactly match the negative charges, and they thus deplete both resins.

The only way one can get depletion of only one or the other resin is if the water is very acidic or very basic (not typical of drinking water) or if there are uncharged ions that become charged one way or the other in one of the resins. CO2 fits that latter description, is very common in well water, and is nearly always the cause of selective anion depletion.
Interesting. I have a very similar issue and I was tempted to send out for ICP tests, until I saw your post. I will installation degassing setup soon. For curiosity sake, if properly performing degassing setup does not cure my ills, which direction shall I proceed in?
 
Interesting. I have a very similar issue and I was tempted to send out for ICP tests, until I saw your post. I will installation degassing setup soon. For curiosity sake, if properly performing degassing setup does not cure my ills, which direction shall I proceed in?

Bad membrane? There are no chemicals in drinkable water other than CO2 that typically cause rapid anion depletion in an ro/di system
 
Bad membrane? There are no chemicals in drinkable water other than CO2 that typically cause rapid anion depletion in an ro/di system
Membrane was replaced 100 treated gallons ago with a dow filmtek membrane. Thank you for chiming in
 

TOP 10 Trending Threads

WHAT’S YOUR MOST MEMORABLE EXPERIENCE WITH A CORAL THAT LOOKED LIKE IT MIGHT NOT MAKE IT?

  • I’ve seen a dramatic comeback. I would have sworn it was a goner

    Votes: 22 43.1%
  • A slow recovery, and it got back to looking healthy

    Votes: 11 21.6%
  • It came back some, but never looked as good as it used to

    Votes: 4 7.8%
  • I tried to save one, but it didn’t make it

    Votes: 7 13.7%
  • Mine is still struggling...no comeback yet

    Votes: 3 5.9%
  • I’ve never had a coral in serious trouble

    Votes: 0 0.0%
  • See, this is why I don’t keep corals

    Votes: 2 3.9%
  • Other (Post in the comments)

    Votes: 2 3.9%
Back
Top
Home
Post thread…
Market
What's new