Fishroom Floor

  • Thread starter Thread starter DaddyO NJ
  • Start date Start date
  • Tagged users Tagged users None

DaddyO NJ

Active Member
View Badges
Joined
May 19, 2018
Messages
103
Reaction score
20
What state or country do you live in
New Jersey
Rating - 0%
0   0   0
I am converting a 12’ x 6’ room in my basement to a fishroom. Current floor is concrete with a peeling paint on it. (Previous owner did a quick paint job to make the room look good, but it’s chipping up. I plan on scraping it up and want to put something down that will be non-skid.

what is the recommendation? Garage floor epoxy? Or is the stuff for pool decks better since it is rated to withstand salt swimming pools?
 
I'll let others jump in and answer your specific question, but I will ask if you have figured out where the water will run from the different areas in the room. Odds are you will figure that out soon enough, but it is better to understand that now and make any adjustments if you can. Good luck!
 
I think I have it figured out. There is already a sink in the room and one wall has electrical panel, gas meter and water meter. That leaves me with one 6’ empty wall near the sink
 
Never bothered to paint the floor of my basement fish room.
 
I would probably mix up paint with a couple handfuls of sand and go over the paint that is already down there rather than going through the effort of trying to scrape it off
 
The epoxy stuff is nice, but you'd def have to put in the flakes/texture so you don't slip/bust your rear. Once I finally retire...one day...in my "forever house"...I've always love the thought of doing the epoxy on the floor and then putting down some type of vented/garage floor tiles like these Grid-Loc ones. Have whatever falls through go toward a drain...a reefer can dream right?
 
I would just scrape it clean and not put anything down. Just my $.02
 
Concrete is porous. It will absorb water and in our hobby it is when, not if, we will have a flood.

Floors are tough to prep if they have been painted before. I started with a belt sander and also tried a wire brush. I ended up using a concrete grinder rented from Home Depot. It was very quick.

I used cement backerboard for the first 3 inches of my wall and put epoxy on the backerboard and the floor - no seam in the room.

I used a pure epoxy on mine. West Systems Epoxy in my case. I spoke with their tech support line twice to ask questions - very helpful.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new