GHL Leak detect - pump shut off programing needed.
- Thread starter AZMSGT
- Start date
- Tagged users None
:)
ScottB
7500 Club Member
And incase some other APEX user clicked through to find the same answer about 3/4 down the LDK tutorial, you will find this:
Programming Energy Bar Outputs
Let’s look at an example for turning off an EnergyBar outlet if a leak or water on the floor is detected.
1. Click on the ‘Expand’ Icon
and then the ‘Outputs’ Icon
on your Apex Fusion Dashboard.
2. Click on an EnergyBar outlet you would like to have turn OFF when a leak probe detects water.
Note: Your return pump, ATO pumps, etc. would be a good outputs to have turn OFF if a leak is detected by the probe(s).
3. Switch the ‘Control Type’ to Advanced. You will see the programming window below open for you to add new programming. Add the lines below to it to the end of your current programming.
existing programming
If Swx#_1 CLOSED Then OFF
If Swx#_2 CLOSED Then OFF
Notice in this example we have changed the ending result to ‘OFF’ instead of ‘ON’ like used in the email program. This is because we want this Energy Bar outlet to respond to leaks by turning ‘OFF’.
Add lines for Swx#_3 and/or Swx#_4 if you have additional leak detection probes.
Programming Energy Bar Outputs
Let’s look at an example for turning off an EnergyBar outlet if a leak or water on the floor is detected.
1. Click on the ‘Expand’ Icon
2. Click on an EnergyBar outlet you would like to have turn OFF when a leak probe detects water.
Note: Your return pump, ATO pumps, etc. would be a good outputs to have turn OFF if a leak is detected by the probe(s).
3. Switch the ‘Control Type’ to Advanced. You will see the programming window below open for you to add new programming. Add the lines below to it to the end of your current programming.
existing programming
If Swx#_1 CLOSED Then OFF
If Swx#_2 CLOSED Then OFF
Notice in this example we have changed the ending result to ‘OFF’ instead of ‘ON’ like used in the email program. This is because we want this Energy Bar outlet to respond to leaks by turning ‘OFF’.
Add lines for Swx#_3 and/or Swx#_4 if you have additional leak detection probes.
ScottB
7500 Club Member
Roger that. Your poise is admirable. I've witnessed more than enough vitriol against a few companies. For both your sakes I hope it concludes to your satisfaction. Sorry for the trouble.
Similar threads
