Hydros turn off ATO on Rope Leak Detection

[tigresteve09]

I just got my Hydros and working on setting it all up. I want to stop all the return pump, wave makers and ATO pump if the rope leak gets activated from water contact.

I was able to setup the return pump but I can’t figure out the ATO pump. I got the tripe sensor optical unit and it looks like I can only set the ATO pump to read off that. (Hope that makes sense).

How to make the ATO pump shut off if the rope leak sensor ever gets triggered?

 

[tbrown]

Change the input count to 2.

 

[tbrown]

Take a screen shot of the ATO settings. My ATO is an aftermarket setup on the XP8.

 

[tigresteve09]

Change the input count to 2.

I don’t see where you change the input count to 2

 

[tbrown]

"Depends On"

 

[tbrown]

Choose the return pump there. "Off if Off"

 

[n2585722]

Yes, use the depends on set to return pump to turn off the other outputs you would want off if the return is turned off. I would set the ATO, AWC, skimmer and the heaters if they are not actually in the tank to turn off if the return pump is off.