Ghl profilux issues

[jhadaway]

I bought a used profilux about a year and a half ago. Because of delays moving down my new tank, im just getting into it. Ive updated the firmware and physically everything is working. Digitally not so much. Im hoping that im missing something here. Im following the website instructions to the letter and not much programming is working. Ive wasted days on it so here goes.

Temp probe reads 0

Added 2 tunze1 cables for 0-10v control. I 6105 runs constant at about 30% the other does nothing.

Added a new optical sensor and a float sensor. Set up an ato. Pump runs non stop bc im assuming the sensor isn't reporting. No reporting acts the same as open.

It doesnt seem like any of the ports are doing anything. Firmware is up to date. I opened it up and nothing is disconnected. Im in 2 maxi dosers, 3-4 head dosers, a kh director and 2 power strips. I wanted a tank that could be automated a little.

Has anyone experienced any of this?

 

[KStatefan]

I would start with one item like the template since it should be the simplest. Verify it is hooked up correctly 0 C is what it would show if the sensor was disconnected

 

[jhadaway]

The temp probe came with the used profilux so i cant say100% its ok, but the level sensors are fresh out of the box new. The problem im having is that it doesn't tell you they are connected. I can enable them but thats it. Im looking for a win with one thing. The tunze 6105s are running at a constant speed. No matter what i do to the pump group.