GHL Profilux power sockets state (feature request)

[Seregus]

Greetings,

I’m quite familiar with profilux programming logic, but I always was missing one simple, simplest thing, which would significantly reduced programming knowledge required and speed up the process: turn on any socket if selected socket is on, turn off any socket if selected socket is off.

This means I for example configure return pump socket for many conditions and etc and instead of, for example, apply same logic to UV light (which is fed from return) so its also switches off if return is off, I would simply say UV light socket to copy state of return pump socket.

Why is it better? Well if for some reason I decide to power off manually return pump socket, the UV would switch off as well! While currently I would have to manually switch off both.

Any GHL people here to tell me if this is something they might put on a road map?

 

[Lasse]

Why is it better? Well if for some reason I decide to power off manually return pump socket, the UV would switch off as well! While currently I would have to manually switch off both.

I agree that it will be easier to handle some tasks if you could copy a status from another socket but the task above is easy to handle - just create a maintenance program something like below. socket 1 = return pump, socket 2 = UV light

​

Sincerely Lasse

 

[Seregus]

Yes of cource, this is what I will be doing. But I think following socket state (or reverse state) is way way easier for most people to understand