- Joined
- Apr 13, 2020
- Messages
- 201
- Reaction score
- 27
Hi
So i asked this in the Gyre forum but didnt get much luck
I have 2 icecap units. 2 maxspect gyres. linked to my apex. They both work. They both Run. They both have new boards.
However, One gyre is controlled and follows the set program. The other Gyre just does what it wants and keeps the same speed. The apex doesn't control it. I have confirmed with Apex that var1/var2 are both running the alternating profiles. I press play and one goes through the steps and the other doesnt.
1) Swapped Icecaps to var3/4 on Apex -ICECAP2 Bottom Red light flashing
2) Swapped Icecaps to var1/2 on Apex -ICECAP2 Bottom Red Light Flashing
2) Swapped Radio cable between icecaps ICECAP2 Bottom Red Light Flashing.
3) Cutting power from button one and plugging back in allows the gyre to work at FULL power for about 30 mins before stopping. Afterward, ICECAP2 Bottom flashes Red.
4) Apex can turn both the gyres off toggling the VAR speed off slider.
icecaps have been check by coralvue last week. i sent them to them and they said they are working and the problem is the apex. I have contacted apex who did a remote thing and said the programming was fine since its the brs profile.
kinda at a loss now how to get it working
So i asked this in the Gyre forum but didnt get much luck
I have 2 icecap units. 2 maxspect gyres. linked to my apex. They both work. They both Run. They both have new boards.
However, One gyre is controlled and follows the set program. The other Gyre just does what it wants and keeps the same speed. The apex doesn't control it. I have confirmed with Apex that var1/var2 are both running the alternating profiles. I press play and one goes through the steps and the other doesnt.
1) Swapped Icecaps to var3/4 on Apex -ICECAP2 Bottom Red light flashing
2) Swapped Icecaps to var1/2 on Apex -ICECAP2 Bottom Red Light Flashing
2) Swapped Radio cable between icecaps ICECAP2 Bottom Red Light Flashing.
3) Cutting power from button one and plugging back in allows the gyre to work at FULL power for about 30 mins before stopping. Afterward, ICECAP2 Bottom flashes Red.
4) Apex can turn both the gyres off toggling the VAR speed off slider.
icecaps have been check by coralvue last week. i sent them to them and they said they are working and the problem is the apex. I have contacted apex who did a remote thing and said the programming was fine since its the brs profile.
kinda at a loss now how to get it working