Hanna salinity checker vs tropic Marin hydrometer?

  • Thread starter Thread starter ReefED!
  • Start date Start date
  • Tagged users Tagged users None

ReefED!

Valuable Member
View Badges
Joined
Oct 20, 2022
Messages
1,116
Reaction score
855
Location
USA
What state or country do you live in
Texas
Rating - 0%
0   0   0
Who’s lying?

IMG_1246.jpeg
IMG_1245.jpeg
 
Interesting! Do you have access to a salinity calibration solution? Have you tried it at different salinities? Without any further data I would lean toward the hydrometer, but I also keep a salinity, conductivity, and pH solutions on hand for confirmation of my probes and test equipment.
 
Honestly I'd have to go with the hydrometer. Other than temp correction (which is minimal) there's nothing to be "off". I use it as the standard to calibrate my refractometer and confirm tank every now and then.
 
I do have a bunch of the Hanna checker solution, which I calibrate every 2-4 weeks on.

My LFS found that my salinity was a bit high - which may have been the cause of some of my mysteriously unhappy corals...

So I got the tropic marin hydrometer
 
My hanna checker would never stay calibrated properly even using the calibration fluid. Wasted months with angry corals till I bought the tropic Marin and never looked back
 
My Hanna always reads lower then my hydrometer

Average Hanna this year SG 1.0239
Average Tropic Marin this year SG 1.0258
 
Hydrometer will do the job just fine
 
Do yourself a favor and ditch the Hanna calibration fluid and use the Neptune fluid. I get exactly the same readings with the Hanna salinity checker against the TM hydrometer when calibrating it with the Neptune. The Hanna fluid is always off.

Screenshot_20230914_143555_Bulk Reef Supply.jpg
 
The Hanna Checker is good to have. It should come with the tropic Marin hydrometer though...you need both IMO. The hydrometer for that accurate reading, and the hanna checker for quick checks to make sure your system water and mixed SW are a match
 
I have both and much prefer the Hanna for convenience. However, the Hanna needs to be kept clean (RO rinse) and have probably monthly calibration. The hydrometer is just a pain where I basically have to shut down all flow and then struggle to get a good measurement. It's really meant to be used with a tall cylinder container.
 
From Hanna website:

Salinity Accuracy±1 ppt for 0.0 to 40.0 ppt; ±2 ppt for readings over 40.0 ppt; ±1 PSU for 0.0 to 40.0 PSU ; ±2 PSU for readings over 40.0 PSU; ±0.001 S.G.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 14 17.7%
  • Fish or coral food

    Votes: 4 5.1%
  • Test kits or reagents

    Votes: 8 10.1%
  • Filter media or replacement fleece

    Votes: 4 5.1%
  • RO/DI filters or supplies

    Votes: 13 16.5%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 9 11.4%
  • I keep a backup of everything

    Votes: 21 26.6%
  • Other (Post in the comments)

    Votes: 6 7.6%
Back
Top
Home
Post thread…
Market
What's new