Heater probe placement

Where does everyone put the heater probes for controlling their heaters?

  • In the sump in the same section with the heaters

    Votes: 1 12.5%
  • In the main aquarium

    Votes: 3 37.5%
  • In the same section as the heaters in AIO

    Votes: 0 0.0%
  • In the sump, different section than heaters

    Votes: 4 50.0%
  • In the back of AIO in different section than heaters

    Votes: 0 0.0%
  • Other, please explain

    Votes: 0 0.0%

  • Total voters
    8
I put my probes in the sump in the section before the heaters, so I am getting a more accurate representation of the tanks temp (without having the probes in the tank itself).
 
In proximity of the heaters. The reason is if circulation stops.....say a heater in the sump and the probe in the DT and the return pump fails......the probe will be calling for heat, and the sump will be cooking hot.
 
In proximity of the heaters. The reason is if circulation stops.....say a heater in the sump and the probe in the DT and the return pump fails......the probe will be calling for heat, and the sump will be cooking hot.
I never even thought about that. I just didn’t want the probes visible in my display.
 
I put my probes in the sump in the section before the heaters, so I am getting a more accurate representation of the tanks temp (without having the probes in the tank itself).
That's probably what I'll do and have done in the past. And that also goes along with what redfishbluefish mentioned about a failed return pump. Both of my heaters are right next to my return pumps in my AIO, I guess the chamber right after the filter sock would be the perfect spot along with the rest of the probes.
 
I go with the overflow box or near the drains in the sump. Since this is the temp of the actual tank without being in the actual tank.

For most systems anywhere with decent flow is fine really.
 
In the first section of the sump, right under the overflow and emergency pipes.
My reasons were that this is as close to the tank as you can get without being visible and it looked neat when plumbing everything in! I appreciate that any temperature drop through the sump could be calculated but It works for me.

It's a good point about protecting against return pump failure. However, I know the cycle time for my heaters and I have set my Inkbird will notify me if the they have been on for too long essentially warning of pump failure.
 

TOP 10 Trending Threads

WHAT KIND OF REEFING DEAL ARE YOU HOPING TO PICK UP THIS BLACK FRIDAY?

  • A whole new aquarium or complete system

    Votes: 2 9.5%
  • Lighting, pumps, or other major equipment

    Votes: 3 14.3%
  • Controllers, testing, dosing, or automation gear

    Votes: 2 9.5%
  • Dry goods and restocks, like salt, media, or food

    Votes: 2 9.5%
  • Corals! Must...Have...CORALS!!!

    Votes: 5 23.8%
  • Fish or other livestock

    Votes: 0 0.0%
  • Rock, sand, or other aquascaping supplies

    Votes: 1 4.8%
  • I’m browsing, but don’t have a specific target

    Votes: 4 19.0%
  • I’m not shopping for reef deals this year

    Votes: 1 4.8%
  • Other (Post in the comments)

    Votes: 1 4.8%
Back
Top
Home
Post thread…
Market
What's new