Help on Part List

[Ditto]

I am requesting some assistance on getting the correct parts list so I can
order:

I Currently have 2 ORPS probes, 3 PH probes, 2 Salinity probes on my tank along with other accessories, and would like to switch. Details will be in a future post, needless to say a
catastrophic failure.

My current setup:

1 ORP is used for Monitoring a Denitrator
1 ORP is use for monitoring redox in the Sump

1 PH probe i monitoring the Sump
1 PH probe is monitoring my Calcium reactor
1 PH probe is in my Display Display tank in the Tank Return.

1 Salinity Probe is in my Sump
1 Salinity probe is in my Display tank in the Tank Return.

1 Temperature Probe is in my Sump
1 Temperature probe is in my Display tank in the Tank Return.

I have a 1" Flow Monitor off my Return Pump
I have a 3/4" Flow Monitor to my Reefgium

I have 2 MP40 and a MP60

For Outlets
At the display Tank I have 8 Outlets

At the Sump I have 12 Outlets.

Since I am going to need put in a new solution for ATO, I am going to also need
a high, and low sensor to place inside my sump.

I Believe the parts list below is correct but I am not 100% sure, and I am
unsure how many PAB Cables I need

1 Profilux 4 Ultimate Set (Comes with: 1 ORP, 1 PH, 1 Salinity, 1 Temperature
Probe) (1 6 Plug Outlet)
I would Need to install in this unit:
1- PLM-PH/Redox Module
1- PH Electrode

1- Profilux Expansion Box (This is where I am confused so need clarification it
says it comes with a PH. Redox, Salinity and Digital Input for it so if that
that is true all I need is the probes)
1- PH Electrode
1- Redox Electrode
1- Conductivity Electrode Platinum (Do you have one that not Platinum)
1- Temperature Sensor Digital

For Vortech controlling:
1- VorTech-Controller

For Flow Sensors:
1- Flow Sensor 5000 l/h
1- Flow Sensor 9000 l/h

For the automatic Water top Off:
1- Level Sensor Holder Base
2- Level Sensor Fastener angled
1- Level Sensor Floater
1- Level Sensor Optical

For Powerbars
3 More Powerbar 5.1 USA/CND-PAB

1 Display Unit

Is the above list correct? What PAB cables would I need and for what. Do I need
any y type cables, because I am plugin in multiple sensors and float switches?

The Plan is the Base Unit will be in my basement, monitoring all basement
equipment

The Expansion unit will be upstairs monitoring the tank.

I sent an email also to the USA shop site also.
Thanks