Giddyup
Active Member
Apex controlled Led strip on v2 working forever with diy cable and meanwell Driver... NOTE- meanwell Driver not controlled by apex plug, always plugged into regular power strip and only use apex for v2 0-10v dimming.
Recently making use of v3 V4 port for frag led two channels and DO use plugs on Apex... All working fine...
When v3v4 turned on first thing am, APEX Is somehow sending 1.59 volts to v1v2 port and those lights go on????
Tested with physical v3v4 cable completely unplugged and APEX is still send voltage to v1v2 when v3v4 variable outlets go on??? So, it’s not a port plug issue....
Please explain how v1v2 is receiving stray voltage? Is this a defect in Apex Classic brain??? Normally, have v2 on auto and once times on v2 program kick in the v2 dimming works as I programmed... V1 program not used and only setup to test...
Thanks for any and all help.
c927ef91e2521bdd67186438e27d8196.jpg[/IMG]
Recently making use of v3 V4 port for frag led two channels and DO use plugs on Apex... All working fine...
When v3v4 turned on first thing am, APEX Is somehow sending 1.59 volts to v1v2 port and those lights go on????
Tested with physical v3v4 cable completely unplugged and APEX is still send voltage to v1v2 when v3v4 variable outlets go on??? So, it’s not a port plug issue....
Please explain how v1v2 is receiving stray voltage? Is this a defect in Apex Classic brain??? Normally, have v2 on auto and once times on v2 program kick in the v2 dimming works as I programmed... V1 program not used and only setup to test...
Thanks for any and all help.
Last edited:
