Help with 3D Printed Adapter

[markushio40b]

Currently have an Eshopps 300 Sump with a 7” filter sock. Looking to replace my sock with a RedSea Nano Filter roller with fits a 4 inch sock.

Could someone help with a 3D print adapter I could use to fit the roller?

Obviously I could pay for the print and shipping depending on location.

I’m located in North Jersey

 

[RiptideAquaculture]

Your looking for a sock size reduction adapter basically?

 

[RiptideAquaculture]

Here is a 7" plate with a 4" hole. I could put the hole anywhere on the plate. If this is what you're looking for, I can get a little more exact with the dims as everyones 7" sizes seem to be a little different.

 

[markushio40b]

That’s exactly what I’m looking for!

I’m sure the measurements aren’t exact and could probably be shaved down if needed

 

[RiptideAquaculture]

I could print is in a high strength print config that would give you a little extra internal material you could sand down. let me know if you think thats enough.

 

[markushio40b]

Here’s a picture of the sump and filter sock placement

 

[markushio40b]

That would be great!

If you want to message me separately so I can give details for shipping and payment here’s my info

646.417.0528

 

[RiptideAquaculture]

Here’s a picture of the sump and filter sock placement

Might not be a bad idea to play with the roller in the hole area to determine if you want is centered or offset slightly.

 

[markushio40b]

Already tested and centered it perfectly fine

 

[RiptideAquaculture]

 

[markushio40b]

Thank you again for the quick turnaround!!!