Help with mp40's

[B-ridge]

i have 4 mp40's hooked up to my wxm controlled by apex. I recently lost power in my house therefore resulting in my apex programming getting all messed up. I basically had to start over and reprogram everything. From the ato to my auto water change. I noticed recently that my mp40's were staying in 1 mode and that was with the green light on. I could change modes but they no longer where in sync or would change modes like I had programmed. Talking with a friend we both realized this was probably due to the power outage. I cleared out each mp40 individually. I then did what ecotech says as far as hooking up to wxm. I look on fusion and I see that 2 are working but it says 1 is in stall mode and the other is missing.
Can someone please tell me what I am doing wrong or have any suggestions what to try? I see 3 are working and in sync. It's just 1 that is not connecting to wxm for whatever reason. Any and all help is greatly appreciated

 

[BantyRooster97]

Did you resync each one with the wxm and get the blue / yellow flash after?