Here it is! Fenbendazole use against hydroids

  • Thread starter Thread starter twilliard
  • Start date Start date
  • Tagged users Tagged users None
The peroxide has been dosed automatically to the tank for the last 2 weeks.

The reaction has come since I added the panacur last night
Did you separate the fenbendazole before adding into the tank? (Panacur)
 
Did you separate the fenbendazole before adding into the tank? (Panacur)

im not sure if you can.

i used the large granules, rather than the powder, but the large granules were just turning to powder anyway.

the large parts were not balls, like what it looked like in your original post
 
im not sure if you can.

i used the large granules, rather than the powder, but the large granules were just turning to powder anyway.

the large parts were not balls, like what it looked like in your original post
Pay close attention to your tank!
The other elements of panacur may be harmful to the tank.
 
Pay close attention to your tank!
The other elements of panacur may be harmful to the tank.

Will mate.

Luckily I tested in my new frag tank so I only had about a dozen frags in there.

So if it were pure fenbendazole in a new tank that didn't have a build up of worms and brittle stars, just a few hydras on the frag plugs, would you expect to see no reaction at all from the Zoas?

I'm going to have to sort out my DT at some point so if the pure fenbendazole has no negative stress reaction from the Zoas I will go and get the fish bendazole.

I didn't go that route as in the UK it cost over 60 dollar for 3 sachets
 
But obviously worth the money if it rids my hydroids but doesn't kill my Zoas
 
No fenbendazole should have no reactions to zoanthids
Are you in the UK?
 
I have never worked with panacur but seems to be the same as safegurd.
The elements in safegurd (not the fenbendazole ) is harmful to tanks.

This is what it looks like

image.jpg


image.jpg
 
I used the large chunks anyway. But I guessed it was different from the safeguard as that looked like the bits you seperated where round and uniform
 
Hey Twilliard,

Gonna treat my take today, and I don't have a scale to measure out the correct dosage. I have total water volume of 130 gallons, and planning to use one of those red spoons from my mag test kit that says 0.05 ml. You said you used 1 scoop to 3 gallons of water for dipping. So can I use that same measurement for treating my hole tank? I have a package of 250mg of fish benfendazole, and from that calculation I would use 43 scoops to treat the whole tank?

Thank you
 
Hey Twilliard,

Gonna treat my take today, and I don't have a scale to measure out the correct dosage. I have total water volume of 130 gallons, and planning to use one of those red spoons from my mag test kit that says 0.05 ml. You said you used 1 scoop to 3 gallons of water for dipping. So can I use that same measurement for treating my hole tank? I have a package of 250mg of fish benfendazole, and from that calculation I would use 43 scoops to treat the whole tank?

Thank you

0.05ml = 50mg

I would assume you want about 3 scoops for a tank treatment
 
3 scoops doesn't seem that much to treat a whole tank. Thanks Fragzilla.
 
3 scoops doesn't seem that much to treat a whole tank. Thanks Fragzilla.

I'm not sure now thinking about it.

I've converted ml to mg and the conversion factor is probably a lot higher than 1-1.

I have worked out an easy way for you to proportion the right amount of fenbendazole.

The pack you said is 250mg and your tank is 130 gallon.

1 mg per gallon means you need half the pack.

If it were me. I would dilute the whole pack into 1l of tank water and dose half a litre of the water into the tank and throw the other 1/2 litre away.
 
Hey Fragzilla, I took your advice. Thanks. Before dosing fenbendazole I removed most of my snails, as many mini brittle star I could get, and my green star polyp. Carbon has been removed and skimmer turned off. Poured in half a liter and now tank is alittle cloudy. Everything looking good so far and Zoas didn't close up. Gonna monitor and wait to do water change tomorrow.
 
Aren't you supposed to leave skimmer on but cut air? You'll might have them in there also.

Stick the airline under the water and dial down maybe.
 
And can you take some photos and report back once it's cleared up please mate.
 
Argh... I missed that part on slowing skimmer and cutting air. Will do that when I get back home in an hour.

I tried taking close up shots with my S6 Edge. and pictures came out awful because of led lights. Any pointers?
 

TOP 10 Trending Threads

WHEN BUYING EQUIPMENT YOUR REEF WILL DEPEND ON, WHAT MATTERS MOST TO YOU?

  • Long-term reports from other reefers

    Votes: 10 50.0%
  • My own past experience with the brand

    Votes: 3 15.0%
  • A simple design I can understand and maintain

    Votes: 2 10.0%
  • Warranty and responsive customer support

    Votes: 1 5.0%
  • Independent testing or detailed reviews

    Votes: 2 10.0%
  • Advice from an LFS or reefer I personally trust

    Votes: 1 5.0%
  • Being able to keep a spare or build in redundancy

    Votes: 1 5.0%
  • Something else? Tell us in the comments

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new