Hi all, Due to user error with No3 test ( Using damp powder ) No3 was reading 5 ppm. It was actually 50+
To keep Po4 under control I run Rowaphos in a reactor 0.04ppm (Redsea pro)
Target for P04 has always been 0.04 ppm
Target for N03 was 10ppm
These were manageble targets for me, because of my error N03 is 50+
Tank 1000 ltr, 7mths , mixed softy's, lps, few sps, I've already lost Bird's-nest and plate Monti.
I can only phisical mix 120ltrs water a week, a little over 10%
I called in my lfs for some advice, but they were very busy, I managed to speak to someone, He said If my P04 was a little higher he could help me with? Then he had to go
In preparation for ? I have turned off the reactor to raise P04
Your help would be appreciated on what I do next. Thx for reading
To keep Po4 under control I run Rowaphos in a reactor 0.04ppm (Redsea pro)
Target for P04 has always been 0.04 ppm
Target for N03 was 10ppm
These were manageble targets for me, because of my error N03 is 50+
Tank 1000 ltr, 7mths , mixed softy's, lps, few sps, I've already lost Bird's-nest and plate Monti.
I can only phisical mix 120ltrs water a week, a little over 10%
I called in my lfs for some advice, but they were very busy, I managed to speak to someone, He said If my P04 was a little higher he could help me with? Then he had to go
In preparation for ? I have turned off the reactor to raise P04
Your help would be appreciated on what I do next. Thx for reading