How to plumb frag tank

  • Thread starter Thread starter Jono1487
  • Start date Start date
  • Tagged users Tagged users None

Jono1487

Community Member
View Badges
Joined
Feb 17, 2018
Messages
44
Reaction score
32
Location
Chicago
What state or country do you live in
Illinois
Rating - 0%
0   0   0
I’m planning a 375g build. I want to have a frag tank plumbed into the system for propagating corals. Any guidance on how to plumb it? Should it go before or after the sump? I’m planning on running a sump with a roller mat, skimmer, and gfo/carbon. I figure it would be best to have the frag tank after the sump so the “dirty” water from the display tank gets filtered in the sump before hitting the frag tank and then heading back to the main display. Anybody with photos of similar setups?
 
Okay thanks. Makes sense. So just put a T on the return line and then put a valve on the end of the T that goes to the frag tank to tune it down to the required rate. I assume the line coming from the frag tank should drain back into the other end of the sump so it could hit the roller mat, heaters, etc. again. I suppose I could add a fuge the same way too.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new