Sensors:
4 Optical Sensors: Saltwater High/Low sensors, Rodi water Hi/Low
2 Solenoids (one for fresh, one for salt)
Dos for the water change
2 floor leak sensors.
I have an EB8 (new one) and 2 fluid management modules down there.
I also have manual float valves as a backup if the sensors fail)
I want to have the system setup like so:
1. When empty turn off dos, and refill the reservoir until the high level. (saltwater) and notify me (once) that it is emptying.
2. After the reservoir is full, Email me once a day until I mix the salt, and set a setting.
3. Dos AWC restarts doing the water changes.
The rodi refill
1. ( I will have an optical sensor in my ATO reservoir at the tank I want to refill remotely. )
2. When at Lo sensor fill until Hi sensor is reached and wait until Lo is hit.
3. Fill ATO until sensor is hit and then turn off.
4 Optical Sensors: Saltwater High/Low sensors, Rodi water Hi/Low
2 Solenoids (one for fresh, one for salt)
Dos for the water change
2 floor leak sensors.
I have an EB8 (new one) and 2 fluid management modules down there.
I also have manual float valves as a backup if the sensors fail)
I want to have the system setup like so:
1. When empty turn off dos, and refill the reservoir until the high level. (saltwater) and notify me (once) that it is emptying.
2. After the reservoir is full, Email me once a day until I mix the salt, and set a setting.
3. Dos AWC restarts doing the water changes.
The rodi refill
1. ( I will have an optical sensor in my ATO reservoir at the tank I want to refill remotely. )
2. When at Lo sensor fill until Hi sensor is reached and wait until Lo is hit.
3. Fill ATO until sensor is hit and then turn off.