Hydor Smart Level Alarm!

[A.Percula]

hey,

I got this new sensor to replace the one I had and the alarm is driving me crazy! The pump is faster than the sensor and touches the alarm sensor every time it tops off water.

How can I remove the alarm device from the board?

 

[Cory]

Id just put a piece of black electrical tape over it to muffle the sound.

 

[CindyKz]

I used a slow pump with that ATO - this one worked great. It didn't work against much head pressure though.

https://www.bulkreefsupply.com/aqua-lifter-vacuum-pump.html

 

[Neo Jeo]

I used super glue in my ADT alarm panel to stop the beeping when setting the alarm lol. I put a ton of glue in the whole and around.

You sure there is not way of turning it off?

 

[A.Percula]

I tried so many ways haha. If I out black tape on top it becomes louder! Its very annoying. I am considering removing the speaker from the board ‍

 

[Hallowhead]

I mean you'd have to remove the main board completely from the housing and than solder the pins going to the speaker. Obviously if the speaker acts as a connection in the circuit this will cause the system to stop working unless you added a jumper cable to make the circuit always connected..

I would recommend what others have said and use hot glue and just surround the entire thing.