The collective between the 2 is still in development. I am waiting for it as well. The wave engine rocks. I have 3.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
The wave engine can still power the Control 4 via a buss cable.The collective between the 2 is still in development. I am waiting for it as well. The wave engine rocks. I have 3.
What connector did you use? Do you have any pics? ThanksI use the drive ports to power my Intllab dosing pumps. The pump draws 120ma from the port So I can run more that one off of one port. If I remember correctly the port can control up to 1 amp or 1.5 amps for both ports. I would not think the fans would draw that much more than a dosing pump. Check the specs on the fans you want to use and see what the operating current is for them.
I think it was a GX12 2 pin connector at the Control 4 and a DC plug at the pump. I got the connectors from Amazon and made the cables. You will have to soldier the wire to the connectors I used a volt meter with the output on to find out which pin was positive. If I remember correctly the center pin is positive on the pump. I already had the DC connectors but I am thinking of getting some with the cord already attached from Amazon. If I remember correctly they are 5.5mm outer and 2.1mm inner on the plug.What connector did you use? Do you have any pics? Thanks
I have actually been waiting for that piece of info.The wave engine can still power the Control 4 via a buss cable.
I think they are around 4ft. I don't have one where I can get an exact measurement.Dumb question but setting at work laying out my tank. How long is the power cord on the power strips?
There is a minimum off time you can set in the advanced settings.How do I config an output to delay start? Like skimmer to delay a minute after feeding, and ATO delay couple minutes after water change.
I see that, but how does it work? For example, if my feed mode is 10 min, and set minimum off time of skimmer to 1 minute, then when the feed mode finished, the skimmer is already off by 10 min, longer than the minimum of 1 min, so it will immediately start.There is a minimum off time you can set in the advanced settings.
Set the minimum off to 1 minute more than the feed time you have set.I see that, but how does it work? For example, if my feed mode is 10 min, and set minimum off time of skimmer to 1 minute, then when the feed mode finished, the skimmer is already off by 10 min, longer than the minimum of 1 min, so it will immediately start.
Just tried it and it's working as I understand. So it don't actually work as delay start.