Hydros failed after update.

Yevoc · May 25, 2021

Wondering if anyone can help.

Previously works Gyre controller.

Prompts for update. App updates. Firmware updates to 186. Everything seems fine.

App comes up.

IC logo in the corner is flashing white/blue and the pumps don't start.

Good chunk of my flow is off line and I have no direction with this.

Anyone run into this and know a work around or fix.

Thanks.

Peace River · May 25, 2021

Let's see if we can get some help...

@shred5 @JeffB418 @n2585722

JeffB418 · May 25, 2021

Dont try to do any changes and immediately contact support.coralvue.com they can fix it in 30 seconds.

Yevoc · May 25, 2021

I fixed it.

For anyone that happens to run into this..
-I went into the schedules.
-Made any changes, just to get apply change.
-Applied it and it started up again.

It was like it didn't carry over the schedules.

JeffB418 · May 25, 2021

Yevoc said:
I fixed it.

For anyone that happens to run into this..
-I went into the schedules.
-Made any changes, just to get apply change.
-Applied it and it started up again.

It was like it didn't carry over the schedules.

Ok so all of your changes migrated over? Or no? Once you did this.

Yevoc · May 25, 2021

Yeah my outputs, schedules, etc were in there. I will see the night schedule kicks over as normal.

n2585722 · May 25, 2021

Yevoc said:
Wondering if anyone can help.

Previously works Gyre controller.

Prompts for update. App updates. Firmware updates to 186. Everything seems fine.

App comes up.

IC logo in the corner is flashing white/blue and the pumps don't start.

Good chunk of my flow is off line and I have no direction with this.

Anyone run into this and know a work around or fix.

Thanks.

What type of controller is this? Did you update the app and the firmware?