IM Nuvo Fusion 10 Anemone Tank - Tank Downsize

[modenda]

Did nitrate and phosphate tests this morning, I really hate color comparison tests… nitrate looked somewhere between 5-12 ppm, closer to 5. Phosphate looked closest to .1 maybe but kinda a different shade so idk. Using Nyos tests

 

[dmsc2fs]

I think that is one of the primary reasons most of us switch to Hannah testers.

 

[HenryTran]

Good job on the stand, super clean setup.

 

[modenda]

Have someone offering me an anemone for cheap, that I could pick up tomorrow but not sure about if it’s been long enough to put it in yet.

Turned on the lights yesterday, been about a month and a half since I put water in the tank. Using the BRS recommended settings from their video at 25%, 12 hours total with 1 hr ramp on each end.

I haven’t water changed in 3 weeks because I was out of the country, will water change tomorrow morning. Just tested nitrates and phosphates and I’m sitting at 12 and .13 respectively. Could bring them both down a tad but not bad.

Thoughts?

I added a Tunze nano ATO since I determined my osmolator is too big. I also added a grommet plug to the front of the control panel in the stand for plugging in the pump I use for water changes. Still haven’t added a heater but it’s warm enough here for now.

 

[Hooz]

Heck yeah! Go for it!

 

[modenda]

Nems are cool…

Finally moved my rock flowers over from my old tank too

 

[modenda]

Showed the clowns a 30 minute video of clownfish hosting a nem this morning, they’re starting to host it already

 

[VegasReefer]

Looks great! What settings are you running your ai prime at?

 

[modenda]

Looks great! What settings are you running your ai prime at?

The settings from this video. Used the 25% scaled ones. Raised the whites and dropped the blues a bit because I like a whiter tank.