In Water Octopus Lid

Particles816

New Member
View Badges
Joined
Jul 27, 2024
Messages
1
Reaction score
0
Location
OFallon
What state or country do you live in
Missouri
Rating - 0%
0   0   0
Has anyone tried to make an octopus lid for a rimless tank that sits below the water line? Maybe like 9 inches below the water level, to allow for filter stuff to still be in water but out of reach.
I was thinking I'd glue a rim and hinge the lid so I can open it to maintenance, feed tube with a lid would be the only consideration. Lid material would be that clear plastic mesh.

I'm trying to reuse a 24" cube.
 
Has anyone tried to make an octopus lid for a rimless tank that sits below the water line? Maybe like 9 inches below the water level, to allow for filter stuff to still be in water but out of reach.
I was thinking I'd glue a rim and hinge the lid so I can open it to maintenance, feed tube with a lid would be the only consideration. Lid material would be that clear plastic mesh.

I'm trying to reuse a 24" cube.

Haven't (don't try to do octopus stuff myself). Biggest concerns would probably be cleaning it and maintaining gas exchange - it's going to be another algae magnet. If you have a sump then you're probably fine with gas exchange, otherwise you're dealing a mesh which is impossible to clean without swapping them out.

Getting a piece of laser cut acrylic would be the way to go, and clamp it on the corners
 
Upvote 0

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new