Industrial Wire Shelf for Water Storage

Yellow Eyes

Community Member
View Badges
Joined
Jun 2, 2016
Messages
34
Reaction score
19
Location
Baltimore, MD
What state or country do you live in
Maryland
Rating - 0%
0   0   0
Has anyone used these industrial wire shelving units (I am looking at these: https://www.webstaurantstore.com/regency-24-x-24-nsf-green-epoxy-wire-shelf/460EG2424.html) to hold water storage containers?

I am in a townhome and have limited storage for holding RODI water and want to make use of some vertical space. The only space I have also blocks the continuous hot water heater, so I needed something modular in case I need to get at it in the future.

I want to use a 32g Brute Trash Can at about 35" off the ground to hold fresh RODI water, and then placing 2x 20g brute totes containers underneath that, about 16" off the ground, one to hold ATO water and one for AWC. Each shelf is rated for 600 lbs. I figure the most that a shelf will see is ~333lbs, assuming I filled both 20g containers to the brim, which leaves me well short of the rating. I am just unsure if the "split sleeve" method of holding these shelves on will work.
 
The weight isn't an issue, we use these in food industry and max them out no problem.

They will and do rust quickly. The epoxy coating will also chip and rust easily.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new