Innovative-Marine Cam-Lock control board brackets

[reefiniteasy]

Hey everyone. I had a friend, @Ellery make these for me. They are 3D printed brackets made to slide over the IM cam-locks that hold .5” Statboard. Now I can relocate my control board into my APS stand. Such a necessary accessory if you have an APS stand. Here is the file so you can print your own or reach out to him if you need a set printed.

https://www.thingiverse.com/thing:5143444
I ordered my .5” Starboard from www.boatoutfitters.com

 

[chrisriker]

What size stand is this for? And how big is the starboard sheet you ordered?

 

[reefiniteasy]

What size stand is this for? And how big is the starboard sheet you ordered?

The cam-lock mounts will work for any IM APS stand. This is the stand from the 25 Lagoon. I order .5” Starboard sheets that are roughly 2’x2’.

 

[Ioncewaslegend]

Out of curiosity, how did you get the cam locks to fit in there? The ones I have aren't slotting into the 'slot' since the circular part where you tighten/untighten the cam locks is too tall.

 

[Ioncewaslegend]

Out of curiosity, how did you get the cam locks to fit in there? The ones I have aren't slotting into the 'slot' since the circular part where you tighten/untighten the cam locks is too tall.

For those looking to do this in the future, I figured it out. There's a small recessed 'tab' in front of the circular screw that you tighten/loosen when using the cam. Push the tab down with a flathead screwdriver, and you can push the raised circular screw down enough to slot it into the printed slot.

 

[jgsolo32]

Hey everyone. I had a friend, @Ellery make these for me. They are 3D printed brackets made to slide over the IM cam-locks that hold .5” Statboard. Now I can relocate my control board into my APS stand. Such a necessary accessory if you have an APS stand. Here is the file so you can print your own or reach out to him if you need a set printed.

https://www.thingiverse.com/thing:5143444
I ordered my .5” Starboard from www.boatoutfitters.com

 

[jgsolo32]

Do you know if @Ellery is still around? Tried starting a convo with him but no response thx

 

[jgsolo32]

Nvm I had someone build the brackets.

 

[jgsolo32]

Also these only work for those APS cabinets without the side doors. Gonna try to use them bit will have to pre measure exact board measurements and glue them to the brackets.

 

[jgsolo32]

You can use them with the side doors but then the doors will remain shut.

 

[Ellery]

Do you know if @Ellery is still around? Tried starting a convo with him but no response thx

Sorry been in and out but glad were able to use my design.