Innovative-Marine Cam-Lock control board brackets

[reefiniteasy]

Hey everyone. I had a friend, @Ellery make these for me. They are 3D printed brackets made to slide over the IM cam-locks that hold .5” Statboard. Now I can relocate my control board into my APS stand. Such a necessary accessory if you have an APS stand. Here is the file so you can print your own or reach out to him if you need a set printed.

IM APS Frame Control Board Mounts by Ellery

Some custom parts needed to add a custom control board to an Innovative Marine Nuvo 40 APS tank stand. It was designed specifically to hold 1/2" thick Starboard and slide onto Innovative Marine Cam Locks. Ideally you would want some wire saver grommets to custom fit through the board as well. 2"...

www.thingiverse.com

I ordered my .5” Starboard from www.boatoutfitters.com

 

[chrisriker]

What size stand is this for? And how big is the starboard sheet you ordered?

 

[reefiniteasy]

What size stand is this for? And how big is the starboard sheet you ordered?

The cam-lock mounts will work for any IM APS stand. This is the stand from the 25 Lagoon. I order .5” Starboard sheets that are roughly 2’x2’.

 

[Ioncewaslegend]

Out of curiosity, how did you get the cam locks to fit in there? The ones I have aren't slotting into the 'slot' since the circular part where you tighten/untighten the cam locks is too tall.

 

[Ioncewaslegend]

Out of curiosity, how did you get the cam locks to fit in there? The ones I have aren't slotting into the 'slot' since the circular part where you tighten/untighten the cam locks is too tall.

For those looking to do this in the future, I figured it out. There's a small recessed 'tab' in front of the circular screw that you tighten/loosen when using the cam. Push the tab down with a flathead screwdriver, and you can push the raised circular screw down enough to slot it into the printed slot.

 

[jgsolo32]

Hey everyone. I had a friend, @Ellery make these for me. They are 3D printed brackets made to slide over the IM cam-locks that hold .5” Statboard. Now I can relocate my control board into my APS stand. Such a necessary accessory if you have an APS stand. Here is the file so you can print your own or reach out to him if you need a set printed.

IM APS Frame Control Board Mounts by Ellery

Some custom parts needed to add a custom control board to an Innovative Marine Nuvo 40 APS tank stand. It was designed specifically to hold 1/2" thick Starboard and slide onto Innovative Marine Cam Locks. Ideally you would want some wire saver grommets to custom fit through the board as well. 2"...

www.thingiverse.com

I ordered my .5” Starboard from www.boatoutfitters.com

 

[jgsolo32]

Do you know if @Ellery is still around? Tried starting a convo with him but no response thx