Introducing an Home assistant integration for Hydros

[BR260354]

Late on the followup, toddler twins will do that LOL

I did manage to build a HA/Shelly failsafed heater outlet (15a capacity)...but havent had time to implement yet. Testing worked though. XP8 outlet on/off will toggle it as a "dumb" relay while HA monitors the temp and has emergency backup control to turn the outlet on/off if anything goes wrong in hydros. This only came about because i needed something better than a 10a smart plug and thanks to this integration!

I did notice however that HA isnt pulling my 0-10v input sensors ( i have an ato water level sensor and an external humidity sensor run in via a breakout box.

Ill try and post some more useful observations at some point, but this stuff may be taken care of by the new API?

so, as a failsafe backup, you want HA to turn off (or on) the Shelly based on the temperature of the tank? If so, yes, you can do that with either Hydros integration above...as far as getting that temperature. However, if as you say Hydros has an issue, you may not get the temperature reading.

I use the XP8 for my Helios heaters - Helios control with XP8 as the backup setup as heater control in Hydros.

 

[nbooks]

so, as a failsafe backup, you want HA to turn off (or on) the Shelly based on the temperature of the tank? If so, yes, you can do that with either Hydros integration above...as far as getting that temperature. However, if as you say Hydros has an issue, you may not get the temperature reading.

its a "failsafe" (in quotes) until i have a secondary/outside hydros temp reading, yes. The main problem i needed to solve was just the need for a >10a capable outlet for my setup and this was the cheapest way.

I'm likely going to add a little esp32 temp probe when i have a chance for backup, my network/house/tank have 18-24 hours of battery backup so the odds of extended equipment or power outages are low, but not zero.

 

[TravisR100]

Found this on HACS but can't figure out how to use it. Downloaded it in HACS. What do I do now?

EDIT: Never mind. Figured it out.

 

[TravisR100]

Found this on HACS but can't figure out how to use it. Downloaded it in HACS. What do I do now?

EDIT: Never mind. Figured it out.

Figured out how to install it. Put in my credentials. It now shows my collective with 42 entities with all my devices. However all of them show "Unavailable"

 

[BR260354]

Try to reload the integration. Sometimes mine goes unavailable and reload works. I setup an automation that watches one of the entities in Hydros. When it goes unavailable, it will reload the integration.

 

[TravisR100]

Tried that. No difference. All still show as "Unavailable."