Is it my PH probe or something else?

  • Thread starter Thread starter ChrisQ0904
  • Start date Start date
  • Tagged users Tagged users None
I posted a similar thing last week. We had 1 day of nice weather so I opened all windows and by the next day I went from a low of 7.55 to a low of 7.8. I'm pretty convinced it's CO2. It got hot again, with windows closed I can see Ph drifting down again. I also use CO2 media, takes at least a week or more to get used but still struggles with hot weather and closed house. I agree if your co2 media is getting used in 1 day it's probably a co2 issue and not a bad probe. I also just added a line into my co2 media from outside today. I'll see how that goes.
 
So nothing to freak out about too much just yet? I'm just flirting between bad and ok.
I would look into it if I were you. Normal is 400ppm so you could be as high as 1600. I doubt you are that high but I would test it.
 
I have been running CO2 media and a line outside for about 3 weeks. My ph runs 7.8 to 8.02. is there anything I can do to bump it up a little more.
 
I have been running CO2 media and a line outside for about 3 weeks. My ph runs 7.8 to 8.02. is there anything I can do to bump it up a little more.
What kind of drains do you use in your system? Are they pulling in a lot of air?
 
That is about where my tank is running. I'm happy with those numbers as I was running 7.55 for lows. I am also running Kalk water in my ATO. I can't think of anything else to do except wait for better weather.
 
I believe it is called the Durso. It is a 120gl and it looks like it has quit a bit of air in the sump area.
 
You might try this:

co2chart.jpg
 
You might try this:

co2chart.jpg
According to that chart I should be good.

Side note, I checked my ph a few min ago at 10pm and it's back down to 7.5 with the skimmer line running outside. I think I'm just going to give up, corals are happy and I should just leave it at that.
 
I believe it is called the Durso. It is a 120gl and it looks like it has quit a bit of air in the sump area.
This is why you will only get limited results from your CO2 filter on your skimmer. Your drains are pulling in a ton of air from in the house that the air from the skimmer has to compete.

I run Durso's myself so see a similar issue. My understanding is that people who run a full siphon drain see much better results from running skimmer lines outside or through a filter.
 
You might try this:

co2chart.jpg

Nice chart. This says that all the urban legend about c02 affecting ph in your tank may be misleading. My ph hovers around 7.9 to 8.0 . I'm not gonna freak and buy more snake oil. Thanks!
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new