Is this one going to make it??

Paul Howard

Active Member
View Badges
Joined
Dec 21, 2017
Messages
148
Reaction score
61
Location
Philadelphia
What state or country do you live in
Pennsylvania
Rating - 0%
0   0   0
Arrived overnight for 10:30 AM del., 1.5 hr. late, 85 degrees... had it for 40 minutes in this pic!
dead coral.jpg
 
Oh wow, do you have a better photo? kinda hard to tell whats going on in this pic. Is there tissue missing?
 
Yes, lots of tissue gone, you can see little piece of tissue stretching btwn. remaining tissue
 
If your system is healthy there's a SLIM chance it could retain what tissue is left and regrow, but that's hoping for the best. Looks like it overheated.. I don't think 1.5hrs late would make a difference honestly. Hopefully you can get a refund from the seller.
 
definitely could have been hotter than 85 at some point, heat packs are hotter in 1st hour or 2?
 
definitely could have been hotter than 85 at some point, heat packs are hotter in 1st hour or 2?
In general they are hottest at the start yes. The "good" ones don't get any hotter than about 110F and then just maintain a more even temp longer. But that's why you pack a few layers between the bags and the heat pack. If it was something like glove warmers or something like that, those get much hotter.
 
Most heat packs stop working when the O2 is out of the small box... then they fire right back up once you open the box.
 
9 hrs later, it's well done! Thanks for your thoughts and prayers. Good news is I'm pretty sure I successfully shipped a WD (about the size of avatar pic) Philly to SF CA yesterday.
skelaton.jpg
 
You sure did buddy, it's so beautiful too.

I'm happy to hear the vendor will replace your Homewreaker, they should have checked the weather forecast before packing the box.
 

TOP 10 Trending Threads

WHAT’S USUALLY THE FIRST CLUE THAT SOMETHING IS OFF IN YOUR REEF?

  • A fish’s behavior or appetite changes

    Votes: 6 10.9%
  • A coral looks different or stops opening normally

    Votes: 38 69.1%
  • Water clarity or surface appearance changes

    Votes: 7 12.7%
  • Equipment sounds or flow seem different

    Votes: 7 12.7%
  • A test result catches my attention

    Votes: 13 23.6%
  • Algae or other growth starts changing

    Votes: 12 21.8%
  • I usually notice when the problem is already obvious

    Votes: 3 5.5%
  • It depends on what’s going on

    Votes: 9 16.4%
  • Other (Post in the comments)

    Votes: 1 1.8%
Back
Top
Home
Post thread…
Market
What's new