Isolated bubble algae on plug/coral skeleton - dip?

bill.mccrary42

Community Member
View Badges
Joined
Jan 15, 2023
Messages
29
Reaction score
8
Location
Indiana, USA
What state or country do you live in
Indiana
Rating - 0%
0   0   0
Small amount of bubble algae, seems isolated to just the plug and side of the skeleton of an acanthastrea frag. I've manually scraped it off a couple times but comes back. I can easily remove the entire frag and dip it. I've seen to use hydrogen peroxide, but not seen anything specific to acanthastrea so a little nervous. Can anyone please confirm if that's what they'd do, or have done w/ their experience? Just the 'typical' dip %/time etc? Thanks in advance!
 
Yes sorry - I didn't dig hard enough, and later found this video and followed it. I did make sure to scrape off all visible bubble algae outside the tank too. This AM the corals look ok but haven't yet fully extended.

 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.9%
  • Fish or coral food

    Votes: 5 5.3%
  • Test kits or reagents

    Votes: 10 10.5%
  • Filter media or replacement fleece

    Votes: 5 5.3%
  • RO/DI filters or supplies

    Votes: 15 15.8%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.6%
  • I keep a backup of everything

    Votes: 24 25.3%
  • Other (Post in the comments)

    Votes: 7 7.4%
Back
Top
Home
Post thread…
Market
What's new