Super happy so far, but I have a lot of learning to do regarding programming and other controls with the system. I am awaiting a probe holder to be delivered for final placement, as well.
So far I'm really loving the system and trying to pace myself on accessories for the system (leak sensors, flow meters, do I want a KHD??, ATO level monitoring???)
One question though, I noticed my conductivity was continuously dropping since yesterday afternoon. Strange, but I'm learning a new system so no biggie. I just checked the probe and there were bubbles on the probe (I'm thinking from when the skimmer shuts off during feeding cycles). Swished the probe to remove the bubbles and readings went right back to expected values.
My question. Can I place a small powerhead in my sump pointed towards the sensors (when I have the holder in place) to eliminate bubbles getting trapped in the probe? Would that affect the readings at all?
So far I'm really loving the system and trying to pace myself on accessories for the system (leak sensors, flow meters, do I want a KHD??, ATO level monitoring???)
One question though, I noticed my conductivity was continuously dropping since yesterday afternoon. Strange, but I'm learning a new system so no biggie. I just checked the probe and there were bubbles on the probe (I'm thinking from when the skimmer shuts off during feeding cycles). Swished the probe to remove the bubbles and readings went right back to expected values.
My question. Can I place a small powerhead in my sump pointed towards the sensors (when I have the holder in place) to eliminate bubbles getting trapped in the probe? Would that affect the readings at all?